Waterjet

---

All Aluminum pieces should be cut using ~12" by 9" of 0.063" 3031 Aluminum

---

Cut

Cut 1 of each of the following files

Forearm Lower Holes

Forearm Upper Holes

Camera Heatsink

Cut 2 of each of the following files

Bearing Mount

Monitor Mount

Shoulder

---

Adjust

Use a metal file to file down any sharp edges

Use the sheet metal bender to bend each Bearing Mount, Forearms, and Monitor Mount 90 degrees, marking where the bend should happen on each

• Bearing Mount: 24.609mm from end
• Forearms: 24.609mm from end
• Monitor Mount: 18.21mm from end

Sandblast all pieces